Here is the title one h1 placeholder text

Release time:

2021-07-02

Coil condenser is prohibited to be used horizontally. Rubber or plastic tubes with an inner diameter less than or equal to ≤20 mm should be used to minimise all kinds of external stresses generated during installation. At the same time, strong vibration caused by stirring and negative pressure pumping should be avoided. Also note that the gas phase cannot flow in the same phase as the cooling water. After installation, slowly drain the water first, then open the water valve, and wait for the outlet to see water before slowly warming up. When using, do not allow a sudden lack of water or sudden sharp rise, the diameter of the outlet pipe is larger than the diameter of the inlet pipe. It is recommended to use downstream negative pressure water supply, not only to reduce the coil pressure, but also to avoid overheating and overpressure when the coil is suddenly damaged after the water into the kettle.

Use of Coil Glass Condenser:
1. Before installation, fill the glass condenser coil with water, plug one port, inflate the other port by 0.1 MPa, and check for no cracks or leaks before installation.
2. Coil condenser is prohibited to be used horizontally. Rubber or plastic tubes with an inner diameter less than or equal to ≤20 mm should be used to minimise all kinds of external stresses generated during installation. At the same time, strong vibration caused by stirring and negative pressure pumping should be avoided. Also note that the gas phase cannot flow in the same phase as the cooling water. After installation, slowly drain the water first, then open the water valve, and wait for the outlet to see water before slowly warming up. When using, do not allow a sudden lack of water or sudden sharp rise, the diameter of the outlet pipe is larger than the diameter of the inlet pipe. It is recommended to use downstream negative pressure water supply, not only to reduce the coil pressure, but also to avoid overheating and overpressure when the coil is suddenly damaged after the water into the kettle.
3. Regularly remove the scale inside the plate glass condenser tube with acid to prevent blockage affecting the cooling effect or damage.
4. When running, turn on the cooling water first, then turn on the heat source. When switching off the car, switch off the heat source first, and then switch off the cooling water.
5、When stopping in winter, turn off the cooling water to prevent the glass equipment from freezing and cracking.